Home > News > How ro solve the Common Toilet Problems

News

How ro solve the Common Toilet Problems
2013-10-10 20:36:04
 

How ro solve the Common Toilet Problems

What can you do if less water is from the tank to flush the toilet bowl?

There are many ways to solve the problems, and here are the aboves:

First of all, you should check the water lever in the tank. It may be too lowly. And please bend the float arm up a little bit to make sure that more water come into the tank if you find that the water lever does not reach the top of the overflow tube within 1 ½ inches.

Secondly, if you find that the water level is correctly but there’s still not enough water to clean the bowl available from the tank, then the problem may be the tank ball seat the bottom of the tank on the flush valve. Thanks to the guide set is too low, the ball drops too fast possibly. So please raise the guide set to make sure that it is staying in the same line with the lift wire. Also, If the guide and the wire are not in the same line, the tank ball will not drop straightly into the valve seat, and the toilet would keep running.

Thirdly, search for the other reason for the inadequate flushing. The small ports around the toilet bowl of the underside can block the wreckage chemicals by the water for the sake of preventing amount of the tank water run out into the bowl. You would be needed a small mirror to help you to check the holes. Moreover, if it is available, a piece of wire hanger or screwdriver can ream out of any debris.

There is another common problems for toilets. As the pipes, toilet tanks could drips water onto the floor. That’s the reason why there are especifically jackets designed to fit over the tank and absorb the moisture. Moreover, there are also drip pans which is suitable for the tank to catch the dripping condensation, so that it won’t damage the bathroom’s floor. A device which is called a temperator valve is another method to combat tank sweating. The valve provides a mixture regulately for hot and cold water, which reduces the difference between the temperature inside and the surrunding the tank. It is just this difference in temperature that leads to condensation, or sweating. Considerring to install a temperator valve whether the water is usually below 50 degrees Fahrenheit in the tank.

 

The temperator valve can lower the toilet tank sweating , which needs supplied connections for both hot-water and cold –water.

The temperator valve ask you to line a hot-water line and the valve together, which would be inconvenient if there is not a relative line next to the toilet. More and more, the temperator valve does not stop the water inside from cooling between flushings. Plus, condensation also can happen on a temperator-equipped toilet. A leaklage may be result in connections loosely or washers defectively on the spud pipe where the water inlet pipe and ballcock are connected to the tank assembly. You may be replace the worn gaskets or washers and get all of the nuts tightly. Then you can have a test on blur in the water.

There is also a possible way that the water is leaking out under the toilet bowl. The drain outlet may be defectively for the reason of the wax ring seal which it is joining into the bowl. The bowl should be removed and a new gasket should be installed if it is happened in the above situation. And the whole toilet should be changed if the leakage is cracking in the tank or the bowl.


Previous   [Return Home] [Print] [Go Back]   Next

Contact Us