touchless toilet flush with Push Buttom QBA-W
Product Description
Long kick 1 second big flush(Water volume 100%)
Intelligent induction to distinguish
between large and small water
The large flush is 100%of the water in the tank
The small flush is 50%of the water in the tank
Small and chic,flush the toilet at the touch of a button
It is convenient for the elderly,children,
and pregnant women to flush without bending over
When you are old,it is inconvenient to bend over.How can you minimize the bending of the elderly?
Elderly people generally have osteoporosis,and some have a series of symptoms such as lumbar disc herniation
and lumbar muscle strain.
How does pregnant mother bend and turn inconvenient to do?
During pregnancy,expectant mothers havea big belly,the fetus presses on the bladder,and urinates frequently.Some pregnant mothersgo to the toilet more than 50 times a day,and itis inconvenient to bend over,tiptoe,turn around,and a series of inconveniences.
Q&A
1) My unit did not require any pairing. I just installed the batteries and it worked. Was this unit already paired? Will the pairing process for the production units still require the 10 – 20 presses of the tranmitter button to pair as previously explained?
Answer: The Signal has been matched before leaving the our factory. However, if there is a Signal drop, it needs to be re-matched as described in the manual.
2) How long does the transmitter button need to be held to activate the full #2 flush?
Answer: Press the button once time for half flush; keep pressing for 1 second or more is full flush.
3) With the #1 half flush cycle, the actuator lever runs smoothly to the top and back down in about 8 seconds, very good. But with the #2 full flush cycle, the actuator lever runs smoothly to the top, but then jams and stalls for a few seconds and then back down, Is that normal? I am worried that this will strain and damage the actuator?
Answer: It is a normal phenomenon. There are no cases currently on the market that are broken due to this reason. Because considering the difference in voltage before and after the battery is used,
it is to make it work normally under the low voltage when the battery is about to run out.
4) The disassembly and reassembly of the transmitter is a little tricky, so I will need a better line drawing than previously supplied in the factory manual showing the components of the transmitter. As I work on the instructions, I will show you what I need.
Answer: Then let us know what line drawing you need, and we will provide it according to your need.
5) On the production units, what is the testing procedure for the transmitter, receiver and actuator motor?
Answer: First install the battery and power on (if signal matching is required, match as described in the manual), plug in the driver cable, and then press the button to check whether the operation is normal.